Modern trends in ceiling light panels are acrylic panels which look like stained glass or a skylight window with a scene of white puffy clouds in a sky that is blue or flowering trees on a bright spring day. Some lighting panel makers can print your art onto the panel for a personalized, trendy addition to your house. Additional types of fluorescent lighting panels include pyramid shaped drop diffusers and lighting covers. Use spectrum bulbs or daylight fluorescent bulbs to bring out all the colours of your home decor and brighten up the room.
Select. Bring some character and to start up the room you can use a sky panorama, which is composed of panels which fit together to make panels that are single or a large image with cloudy skies. For an appearance that is elegant, yet booked, you may use a stained glass print or a marbled glass print in colours that fit your decoration strategy. Order your prints from your regional lighting store. Ask if you’re able to have them cut to size for you, as some shops can do that for you, while placing your order along with your regional lighting store.
Turn off the power to the lighting at the circuit breaker panel. Use a sturdy step ladder to achieve the lighting panels. The tabs on the frame of the panel that is light down to unlock it. Start looking for the frame’s hinged tab side and then take good care of the other side and slowly pull the frame . Tilt the hinged tab end out of the frame to eliminate it.
Set the light panel frame on a flat surface. Pry off the spring clips (if any) that grip in the old panel with a flat-blade screwdriver. Look carefully at the frame and look for screws or tabs which hold it together. Remove the screw thread on one short end to start the panel channel if there are screws. If there are tabs, bend the tabs back.
Analyze the panel that is old. If the panel fit the frame correctly you can use it like a cutting template.
Put on gloves. Eliminate the old fluorescent lighting panel in the housing. Panels are brittle and might be sharp on the edges, so take care when handling them.
Set on the panel and then correct the position over the desired pattern when the panel cut so you keep it, or print. Trace across the panel with a pencil to make a cutting guide line. Assess the perimeter of the interior of the lighting panel, where the panel sits in the frame when it’s set up, with a stride on the frame to obtain the correct size if the panel did not fit properly. Whenever you make the cut transfer these dimensions to the rear of the new fluorescent lighting panels with a metal straightedge and a pencil; position the lines to keep the desired pattern on the panel.
Put on gloves and safety glasses. Set on a sturdy work space. Place the metal straightedge and operate a utility knife utilizing the metal straightedge. Take your time to make certain that the cut is right and doesn’t deviate from the cutting guide. Use a metal straightedge as before and operate an acrylic scoring knife down each cutting guide line four days to score the plank if you are cutting on an panel. Move over the panel to the end of a table or a counter top, align the score line with the edge of the table and then pull the edge down to snap off the acrylic on the line that is . The break is going to likely be an even edge when performed properly.
Set the panel print-side-down against the frame’s end. Align the edges with the frame’s stations and slip it in. Close to the frame and secure it or bend down the tabs to hold it in position. Add in their slots on the frame.
Hold the hinged tab end up to the ceiling lighting fixture. Insert the tabs and then tilt the end of the frame up into position. Push the fixture tabs back into position to lock the panel onto the lighting fixture.